Skip to main content

How do I power cycle (restart) my SolarEdge system?

How to safely restart your SolarEdge inverter to clear communication or production alerts, and what to expect afterward.

Power cycling means turning your SolarEdge system off and back on. It often clears communication alerts, such as "No Site Communication", and gets an offline system reporting again. It takes about 10 minutes. Do it only in dry weather, with dry hands, and only if nothing looks damaged, wet, burnt or hot. Don't open any equipment covers.


​

When should I power cycle my SolarEdge system?

Power cycle your SolarEdge system when your monitoring app shows a communication alert, your system shows offline, or our team asks you to. You don't need to power cycle as routine care. If you have a SolarEdge battery, contact us before you start.


​

Where are the switches?

You'll use these switches to power cycle your system:

  • Inverter ON/OFF switch: a red switch on your SolarEdge inverter, usually above the black dial. Your inverter is usually on an outside wall or in your garage.

  • DC dial: the black dial on the front of the inverter. DC (direct current) is the power your panels make.

  • AC disconnect: a gray box with a lever, outside near your utility meter. It's a shut-off switch for your solar system. Not every home has one.

  • Solar breaker: a breaker labeled Solar or Solar PV in your main electrical panel.


​

An AC disconnect on an outside wall

An AC disconnect on an outside wall


​

A breaker labeled Solar in a home's main electrical panel

A breaker labeled Solar in a home's main electrical panel


​

How do I power cycle my SolarEdge system?

To power cycle your SolarEdge system:

  1. Turn the red ON/OFF switch on the inverter to OFF (0).

  2. Wait 5 minutes.

  3. Turn the black DC dial on the inverter to OFF.

  4. If you have an AC disconnect, pull its lever down to OFF.

  5. Turn off the solar breaker in your main electrical panel.

  6. Wait 30 seconds.

  7. Turn the solar breaker back on.

  8. If you have an AC disconnect, push its lever back up to ON.

  9. Turn the black DC dial back to ON.

  10. Turn the red ON/OFF switch back to ON (1).


​

The inverter restarts by itself, which can take several minutes. When the restart is done, the red fault light on the inverter should go off with no error message.


​

To see the steps on video, watch our power cycle videos: Part 1 and Part 2.


​

What happens after I power cycle?

After a power cycle, your SolarEdge monitoring app can take 24 to 48 hours to show your system again. If you're working with our team, reply to your existing conversation or email [email protected] to tell us you've done it, and include your reference number.


​

If the alert is still there after 48 hours, or the inverter shows an error, request service. Don't keep repeating the power cycle.


​

Common questions


​

Can I power cycle my inverter in the rain?

No. Wait until the equipment and the area around it are dry. Working with electrical equipment in wet conditions can cause a shock.


​

What if my inverter doesn't turn back on?

Check that the solar breaker, the AC disconnect (if you have one), the DC dial and the red switch are all back on. If the inverter still doesn't start, contact us.


​

What if my inverter shows an error after the power cycle?

Don't try more troubleshooting. Take a photo of the error and request service.


​

Related articles

Did this answer your question?